Chevy Cruze Traction Control Warning Light

If the traction control light comes on while you re driving but no other warning lights are illuminated don t panic.

Chevy cruze traction control warning light.

On a front wheel drive vehicle the system operates if it senses that one or both of the front wheels are spinning or beginning to lose traction. Chevrolet cruze owners manual driving and operating ride control systems traction control system tcs the vehicle has a traction control system tcs that limits wheel spin. Earlier this afternoon i received a service stabilitrak and service traction control message on the information display. The main cause of your traction control indication.

Find a safe place to pull over turn off your vehicle and then restart it. For the past week my 2012 cruze lt 60k miles has been flashing stabilitrak check service traction control and the radio cuts out. The traction control and abs warning lights also lit up. Stabilitrak is a gm specific vehicle stability system.

It works by using a complex system of sensors to detect whether or not. Chevrolet cruze owners manual instruments and controls warning lights gauges and indicator traction control system tcs stabilitrak light the stabilitrak or traction control system tcs indicator warning light comes on briefly when the engine is started. My car had a rough idle and if i sit at a red light or let the car run in idle for a few minutes my check engine light starts to flash and service stabilitrak and traction control light comes on i had the code ran and it comes back as a misfire on cylinder 4 i was recommended by the auto zone clerk to have my fuel injectiotors cleaned. Stabilitrak is designed to help prevent accidents by giving you better control of your cruze.

If you have a service stabilitrak warning your cruze will no longer be assisted when a loss in lateral traction is detected. Since other posts about the topic have mentioned weather it was about 40 degrees. I was on the highway going about 70mph when the messages lights appeared. If a fluke in the tcs system triggered the warning light it should turn stay off when you restart the engine.

I have read a bit about it and there may be a problem with a negative battery cable or possibly a troublesome psv and or faulty sensors.